Inspection Procedure

1. Disconnect the kick-down switch connector
2. Measure the resistance according to the value(s) in the table below

   Standard Resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   A61-1 - Body ground	Always	Below 1 Ω

Fig 1: Identifying A61 Kick Down Switch Connector Terminal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to Next Step 

1. Measure resistance according to the value(s) in the table below when kick-down switch is ON and OFF

   Standard Resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   1 - 2	Press continuously (Kick-down switch is ON)	Below 25 Ω
   	Release (Kick-down switch is OFF)	10 kΩ or higher

Fig 2: Inspecting Kick Down Switch Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE KICK DOWN SWITCH ASSEMBLY 

OK: Go to Next Step 

1. Connect the kick-down switch connector
2. Disconnect the ECM connector
3. Measure resistance according to the value(s) in the table below when accelerator pedal is fully depressed or not

   Standard Resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   A5-14 (KD) - Body ground	Fully depressed (Kick-down switch is ON)	Below 25 Ω
   	Release (Kick-down switch is OFF)	10 kΩ or higher

   Fig 3: Identifying Terminal KD Of ECM Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )