Display And Navigation Assembly: Installation

HINT:

A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

1. INSTALL NO. 2 RADIO BRACKET 
   1. Install the bracket with the 2 bolts.
      Fig 1: Locating No. 2 Radio Bracket Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. INSTALL NO. 1 RADIO BRACKET 
   1. Install the bracket with the 2 bolts.
      Fig 2: Locating No. 1 Radio Bracket Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. INSTALL DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET 
   1. Connect the connectors.
   2. Insert the multi-display and attach the 6 clips on its backside.
      Fig 3: Installing Multi-Display

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Install the multi-display with the 2 bolts.
      Fig 4: Locating Multi-Display Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET  (See INSTALLATION )
5. INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER  (See INSTALLATION )
6. INSTALL REAR CONSOLE PANEL UPPER  (See INSTALLATION )
7. INSTALL NO. 3 BOX PANEL  (See INSTALLATION )
8. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY  (See INSTALLATION )
9. INSTALL INSTRUMENT PANEL FINISH PANEL END RH  (See INSTALLATION )
10. INSTALL INSTRUMENT PANEL FINISH PANEL END LH  (See INSTALLATION )
11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
12. INSTALL COWL TOP VENTILATOR LOUVER RH  (See INSTALLATION )
13. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
       NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.