Display And Navigation Assembly: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE INSTRUMENT PANEL FINISH PANEL END LH (See REMOVAL )
REMOVE INSTRUMENT PANEL FINISH PANEL END RH (See REMOVAL )
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 3 BOX PANEL (See REMOVAL )
REMOVE REAR CONSOLE PANEL UPPER (See REMOVAL )
REMOVE CONSOLE PANEL SUB-ASSEMBLY UPPER (See REMOVAL )
REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (See REMOVAL )
REMOVE DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET
1. Remove the 2 bolts.
2. Pull the multi-display to detach the 6 clips on the backside of the multi-display.
  
  Fig 1: Locating Multi-Display Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disconnect the connectors and remove the multi-display.
  
  Fig 2: Removing Multi-Display
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 RADIO BRACKET
1. Remove the 2 bolts and bracket.
  
  Fig 3: Locating No. 2 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 1 RADIO BRACKET
1. Remove the 2 bolts and bracket.
  
  Fig 4: Locating No. 1 Radio Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002