Inspection Procedure

1. Clear the DTCs (see DTC CHECK / CLEAR  ).
2. Start the engine.
3. Allow the engine to idle for 1 minute or more.
4. Read DTCs.

   Result 

   RESULT REFERENCE
   
   

   Display (DTC output)	Proceed to
   B2271	A
   No DTC output	B

B: END (SYSTEM IS OK) 

A: Go to Next Step 

1. Remove the AM2 fuse from the passenger side junction block.
2. Measure the resistance of the fuse.

   Standard resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   AM2 fuse	Always	Below 1 Ω

NG: REPLACE FUSE 

OK: Go to Next Step 

Fig 1: Identifying L12, L13 And DA Main Body ECU Connectors

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the L12, L13 and DA main body ECU connectors.
2. Measure the voltage and resistance according to the value (s) in the table below.

   Standard voltage 

   STANDARD VOLTAGE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   L13-6 (AM1) - Body ground	Always	11 to 14 V
   L12-1 (AM2) - Body ground	Always	11 to 14 V

   Standard resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   DA-40 (GND1) - Body ground	Always	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: REPLACE MAIN BODY ECU