How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the power shoulder belt anchorage system.
• *: Use the intelligent tester or Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM 
   1. Use the intelligent tester or Techstream to check if the CAN communication system is functioning normally.

      Result 

   RESULT CHART
   
   

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

   B:  Go to CAN COMMUNICATION SYSTEM

   A: Go to next step 

4. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B:  Go to step  6

   A: Go to next step 

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. DATA LIST / ACTIVE TEST (see DATA LIST / ACTIVE TEST )
   2. Terminals of ECU (see TERMINALS OF ECU )
6. ADJUST, REPAIR OR REPLACE 
7. CONFIRMATION TEST 

NEXT: END