How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the smart access system with push-button start.
• *: Use the Techstream.
  Fig 1: Aligning Electrical Key Transmitter With Center Of Rear Of Vehicle

  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 11 to 14 V 

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the CAN communication system is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC is output	B

   B: Go to CAN COMMUNICATION SYSTEM  (See CAN COMMUNICATION SYSTEM )

   A: Go to Next Step 

4. INSPECT COMMUNICATION FUNCTION OF LIN COMMUNICATION SYSTEM* 
   1. Use the Techstream to check if the LIN communication system is functioning normally.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      LIN DTC is not output	A
      LIN DTC is output	B

   B: Go to LIN COMMUNICATION SYSTEM  (See LIN COMMUNICATION SYSTEM )

   A: Go to Next Step 

5. CHECK FOR DTC* 
   1. Check for DTCs. Based on the DTCs output above, try to cause the output of the same steering lock system DTC or engine immobiliser system DTC by simulating the symptoms indicated by the DTC.

      Result 

      RESULT REFERENCE
      
      

      Result	Proceed to
      DTC output does not reoccur	A
      Steering lock system DTC output reoccurs	B
      Engine immobiliser system DTC output reoccurs	C

   B: Go to STEERING LOCK SYSTEM  (See STEERING LOCK SYSTEM )

   C: Go to ENGINE IMMOBILISER SYSTEM  (See ENGINE IMMOBILISER SYSTEM )

   A: Go to Next Step 

6. PROBLEM SYMPTOMS TABLE 

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B: Go to step  8

   A: Go to Next Step 

7. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Operation check (see OPERATION CHECK  )
   2. Data List /Active Test (see DATA LIST / ACTIVE TEST  )
   3. Terminals of ECU (see TERMINALS OF ECU  )
8. REPAIR OR REPLACEMENT 
9. CONFIRMATION TEST 

   NEXT: END