Inner Rear View Mirror: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTE:
- After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
REMOVE MAP LIGHT ASSEMBLY (See REMOVAL )
REMOVE INNER REAR VIEW MIRROR COVER (w/o Rain Sensor)
1. Detach the 2 claws and remove the inner rear view mirror cover as shown in the illustration.
  
  Fig 1: Removing Inner Rear View Mirror Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RAIN SENSOR COVER (w/ Rain Sensor)
1. Pull the stopper in the direction shown in the illustration.
2. Detach the 2 claws and remove the rain sensor cover.
REMOVE RAIN SENSOR COVER (w/ Driver Monitor Camera)
NOTE: When removing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".

Fig 3: Locating Rain Sensor Cover Camera And Clip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Pull the stopper in the direction shown in the illustration.
2. While being careful not to apply force to the camera areas, detach the 2 clips and 2 claws and remove the rain sensor cover.
REMOVE INNER REAR VIEW MIRROR ASSEMBLY
1. Disconnect the connector.
2. Using a T20 "TORX" socket wrench, remove the screw and inner rear view mirror.
  
  Fig 5: Identifying Inner Rear View Mirror Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002