Inspection Procedure

1. Check that the brake hold standby indicator light operates normally (see BRAKE HOLD STANDBY INDICATOR LIGHT CIRCUIT  ).
2. If the brake hold operated indicator light does not illuminate although the brake hold standby indicator light is illuminated, check that the following brake hold operation (maintaining brake oil pressure) conditions are met.
   • System is in operation standby state.
   • Shift position is not P or R.
   • Driver is depressing brake pedal and vehicle is fully stopped.
   • Driver is not depressing accelerator pedal.
   • Vehicle is not on steep decline.

   HINT:

   For brake hold operation and completion condition details, refer to the following procedures (see SYSTEM DESCRIPTION  ).

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Select the Active Test mode on the Techstream.

   Combination meter 

   COMBINATION METER REFERENCE CHART
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. Hold	Brake hold operated indicator light	ON / OFF	Observe combination meter

4. Check that the brake hold operated indicator light turns on or off on the Techstream.

   OK: The brake hold operated indicator light turns on or off in accordance with the Techstream. 

NG: GO TO METER AND GAUGE SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

OK: Go to Next Step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Select the Active Test mode on the Techstream.

   ABS/VSC/TRAC 

   ABS/VSC/TRAC REFERENCE CHART
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   BH Operated Light	Brake hold standby indicator light	ON / OFF	Observe combination meter

4. Check that the brake hold operated indicator light turns on or off on the Techstream.

   OK: The brake hold operated indicator light turns on or off in accordance with the Techstream. 

NG: REPLACE SKID CONTROL ECU  (See REMOVAL  )

OK: CHECK INTERMITTENT PROBLEMS  (See CHECK FOR INTERMITTENT PROBLEMS  )