Steering Knuckle: Installation

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.
• A bolt without a torque specification is shown in the standard bolt chart (SS-2).

1. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH  (See INSTALLATION  )
2. INSTALL STEERING KNUCKLE SUB-ASSEMBLY LH  (See INSTALLATION  )
3. CONNECT FRONT NO. 2 SUSPENSION LOWER ARM ASSEMBLY LH  (See INSTALLATION  )
4. CONNECT FRONT SHOCK ABSORBER ASSEMBLY LH  (See INSTALLATION  )
5. INSTALL FRONT STABILIZER LINK ASSEMBLY LH  (See INSTALLATION  )
6. CONNECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH  (See INSTALLATION  )
7. CONNECT FRONT NO. 1 SUSPENSION LOWER ARM ASSEMBLY LH  (See INSTALLATION  )
8. CONNECT TIE ROD ASSEMBLY LH  (See INSTALLATION )
9. INSTALL FRONT DISC BRAKE DUST COVER LH  (See INSTALLATION  )
10. INSTALL FRONT DISC  (See INSTALLATION )
11. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH  (See INSTALLATION  )
12. CONNECT SPEED SENSOR CONNECTOR LH  (See INSTALLATION  )
13. INSTALL FRONT WHEEL 
14. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT  (See INSTALLATION  )
15. CHECK ABS SPEED SENSOR SIGNAL 
    1. Check the speed sensor signal (BC-47).
16. VEHICLE PREPARATION FOR HEADLIGHT AIMING ADJUSTMENT  (See ADJUSTMENT )
17. PREPARATION FOR HEADLIGHT AIMING (Using a screen)  (See ADJUSTMENT )
18. HEADLIGHT AIMING INSPECTION  (See ADJUSTMENT )
19. HEADLIGHT AIMING ADJUSTMENT  (See REASSEMBLY )
20. ADJUST OBJECT RECOGNITION CAMERA 
    1. Adjust the object recognition camera (see ADJUSTMENT ).