LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> LS 460L >> Repair and Diagnosis >> Electrical >> Body Electrical >> Power Source / Wiring >> Battery Current Sensor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Battery Current Sensor: Removal

  1. REMOVE COWL TOP VENTILATOR LOUVER RH  (See REMOVAL )
  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
  3. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  4. REMOVE FRONT FENDER PROTECTOR UPPER RH  (See REMOVAL )
  5. REMOVE BATTERY CURRENT SENSOR 
    1. Disconnect the connector from the battery current sensor assembly.
    2. Remove the bolt, ground terminal and battery current sensor assembly.
      3. Fig 1: Locating Terminal Bolt
      G04945747Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the battery current sensor assembly from the ground terminal.
scientia non olet · About LEMON Manuals