Oil Pressure Switch: Installation

INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY
1. Apply adhesive to 2 or 3 threads of the switch.
  Adhesive:
  
  Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
  
  Fig 1: Applying Adhesive To Threads Of Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a 24 mm deep socket wrench, install the switch.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  NOTE: Do not start the engine within 1 hour after installation.
  
  Fig 2: Installing No. 1 Engine Under Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the switch connector.
INSTALL NO. 1 ENGINE UNDER COVER (See REPLACEMENT )
INSPECT FOR ENGINE OIL LEAK
1. Start the engine. Make sure that there are no oil leaks from the area that was worked on.