Intake Air Control Valve Actuator: Removal

REMOVE COWL TOP VENTILATOR LOUVER RH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTE: After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
REMOVE V-BANK COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE INTAKE AIR CONTROL VALVE ACTUATOR
1. Disconnect the intake air control valve actuator connector.
2. Remove the nut, and disconnect the actuator rod.
  HINT:
  
  When loosening the nut, hold the actuator rod in place so that it does not move.
3. Remove the 2 bolts. Then remove the intake air control valve actuator from the intake manifold.
  
  Fig 1: Locating Intake Air Control Valve Actuator Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002