Shoulder Belt Anchorage Switch: Inspection

1. Measure the resistance according to the value (s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester Connection	Switch Condition	Specified Condition
   2 (UL) - 3 (UP)	UP	Below 1 Ω
   1 (DW) - 3 (UP)	UP	10 kΩ or higher
   1 (DW) - 2 (UL)	DOWN	Below 1 Ω
   2 (UL) - 3 (UP)	DOWN	10 kΩ or higher

   Fig 1: Inspecting Height Adjustable Anchor Switch (For LH Side)

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   If the result is not as specified, replace the switch.

1. Measure the resistance according to the value (s) in the table below.

   Standard resistance 

Fig 2: Inspecting Height Adjustable Anchor Switch (For RH Side)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the result is not as specified, replace the switch.