Data List / Active Test

DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Access / Data List /

According to the display on the Techstream, read the Data List.

Smart Access

SMART ACCESS DATA LIST REFERENCE

Tester Display	Measurement Item/Range	Normal Condition
Sensor Value	Sensor malfunction/NG (Past) or OK	NG (Past): Sensor malfunction OK: No malfunction
Power Supply Short	Short in ECU/NG (Past) or OK	NG (Past): Short in ECU OK: No malfunction
Power Supply Open	Open in ECU/NG (Past) or OK	NG (Past): Open in ECU OK: No malfunction
Motor Driver Short	Short in driver ECU/NG (Past) or OK	NG (Past): Short in driver ECU OK: No malfunction
Motor Driver Open	Open in driver ECU/NG (Past) or OK	NG (Past): Open in driver ECU OK: No malfunction
Lock/Unlock Receive	Steering lock command reception record/ YES or NO	YES: Steering lock / unlock signal received NO: Steering lock / unlock signal not received
Lock Bar Stuck Error	Lock bar stuck malfunction/NG (Past) or OK	NG (Past): Lock bar stuck malfunction OK: No malfunction
Push Start Error	Push button start function malfunction/NG (Past) or OK	NG (Past): Malfunction in push button start OK: No malfunction
IG2 Status	IG2 voltage/ON or OFF	ON: 11 to 14 V OFF: Below 1 V
IG (Lin)	LIN bus start-up status/ON or OFF	ON: LIN bus started-up OFF: LIN bus not started-up
S Code Check	S code match record/NG or OK	NG: S code not matched OK: S code matched
L Code Check	L code match record/NG or OK	NG: L code not matched OK: L code matched
Unlock Request Receive	Steering lock unlock command reception status/NG or OK	NG: Unlock request not received OK: Unlock request received
Lock Request Receive	Steering lock lock command reception status/NG or OK	NG: Lock request not received OK: Lock request received
S Code Check(Past)	S code match record/NG (Past) or OK	NG (Past): S code not matched OK: S code matched
L Code Check(Past)	L code match record/NG (Past) or OK	NG (Past): L code not matched OK: L code matched