LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> LS 460L >> Repair and Diagnosis >> Suspension >> Suspension Control Systems >> Air Suspension System >> Data List/Active Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List/Active Test

  1. READ DATA LIST 

    HINT:

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG) and the Techstream on.
    3. Enter the following menus: Chassis / Air suspension / Data List.
    4. Read the Data List by following the directions on the Techstream screen.

      Air suspension 

      DIAGNOSTIC NOTE TABLE

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      (Up & Down) G Sensor FR G (up & down) front acceleration sensor RH reading /
      min.: -1045.29 m/s2
      max.: 1045.26 m/s2
      0 +/-0.98 m/s2 at still condition Reading changes when vehicle (FR) is bounced
      (Up & Down)G Sensor FL G (up & down) front acceleration sensor LH reading /
      min.: -1045.29 m/s2
      max.: 1045.26 m/s2
      0 +/-0.98 m/s2 at still condition Reading changes when vehicle (FL) is bounced
      (Up & Down)G Sensor Rear G (up & down) rear acceleration sensor reading /
      min.: -1045.29 m/s2
      max.: 1045.26 m/s2
      0 +/-0.98 m/s2 at still condition Reading changes when vehicle (rear) is bounced
      (Back & Forth) G Sensor G sensor reading /
      min.: -4.5952 m/s2
      max.: 4.5593 m/s2
      0 +/-0.98 m/s2 at still condition Reading changes when vehicle is bounced
      FR Height Control Sensor Front height control sensor RH reading /
      min.: -3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      - -
      FL Height Control Sensor Front height control sensor LH reading /
      min.: -3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      - -
      RR Height Control Sensor Rear height control sensor RH reading /
      min.:-3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      - -
      RL Height Control Sensor Rear height control sensor LH reading /
      min.:-3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      - -
      Height Offset Max Display of amount of vehicle height calibration that is possible /
      min.: 0 mm
      max.: 655.35 mm (25.8011 in)
      min.: 0 mm (0 in.) max.: 20 mm (0.79 in.) -
      FR Height Adjust Display of vehicle height offset recorded value of front right wheel /
      min.: -3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      - -
      FL Height Adjust Display of vehicle height offset recorded value of front left wheel /
      min.: -3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      - -
      RR Height Adjust Display of vehicle height offset recorded value of rear right wheel /
      min.: -3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      - -
      RL Height Adjust Display of vehicle height offset recorded value of rear left wheel /
      min.: -3276.8 mm (-129 in.) max.: 3276.7 mm (129 in.)
      - -
      FR After Height Adjust Display of after-calibration vehicle height value of front right wheel /
      min.: -3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      When vehicle height normal: 0 +/-20 mm (0 +/- 0.79 in.)
      When vehicle height is changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/- 20 mm (0.79 +/- 0.79 in.)
      -
      FL After Height Adjust Display of after-calibration vehicle height value of front left wheel /
      min.: -3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      When vehicle height normal: 0 +/-20 mm (0 +/- 0.79 in.)
      When vehicle height is changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/- 20 mm (0.79 +/- 0.79 in.)
      -
      RR After Height Adjust Display of after-calibration vehicle height value of rear right wheel /
      min.: -3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      When vehicle height normal: 0 +/-20 mm (0 +/- 0.79 in.)
      When vehicle height is changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/- 20 mm (0.79 +/- 0.79 in.)
      -
      RL After Height Adjust Display of after-calibration vehicle height value of rear left wheel /
      min.:-3276.8 mm (-129 in.)
      max.: 3276.7 mm (129 in.)
      When vehicle height normal: 0 +/-20 mm (0 +/- 0.79 in.)
      When vehicle height is changing: Varies based on vehicle height After HEIGHT HIGH adjustment: 20 +/- 20 mm (0.79 +/- 0.79 in.)
      -
      Stop Light Switch Stop light switch /
      ON or OFF
      ON: Brake pedal depressed OFF: Brake pedal released -
      COMFORT Switch Absorber control switch
      ON or OFF
      ON: COMFORT OFF: Normal -
      SPORT Switch Absorber control switch
      ON or OFF
      ON: SPORT OFF: Normal -
      Door Switch Door switch /
      ON or OFF
      ON: Open a door OFF: Close all doors -
      Damping Force Switch 1 Height control switch /
      ON or OFF
      ON: Switch is pressed and held OFF: Switch is not pressed -
      Height Control Vehicle height control condition reading /
      ON or OFF
      ON: Vehicle height control operating OFF: Vehicle height control not operating -
      Height Offset Vehicle height offset calibration condition reading /
      ON or OFF
      ON: Vehicle height offset calibration complete
      OFF: Before vehicle height offset calibration
      -
      HV Ready - OFF -
      TD Terminal TD terminal /
      ON or OFF
      ON: Height control is not operating
      OFF: Height control is operating
      -
      TC Terminal TC terminal /
      ON or OFF
      ON: DTC is output
      OFF: DTC is not output
      -
      TS Terminal TS terminal /
      ON or OFF
      ON: During test mode
      OFF: Normal mode
      -
      FR Wheel Speed Front right wheel speed reading /
      min.: 0 km/h (0 mph)
      max.: 255 km/h (159 mph)
      Actual vehicle speed Speed indicated on the combination meter
      FL Wheel Speed Front left wheel speed reading /
      min.: 0 km/h (0 mph)
      max.: 255 km/h (159 mph)
      Actual vehicle speed Speed indicated on the combination meter
      RR Wheel Speed Rear right wheel speed reading /
      min.: 0 km/h (0 mph)
      max.: 255 km/h (159 mph)
      Actual vehicle speed Speed indicated on the combination meter
      RL Wheel Speed Rear left wheel speed reading /
      min.: 0 km/h (0 mph)
      max.: 255 km/h (159 mph)
      Actual vehicle speed Speed indicated on the combination meter
      IG Power Source Voltage ECU power supply voltage /
      min.: 0 V
      max.: 255 V
      Actual ECU power supply voltage: 10 to 14 V -
      Steering Angle Steering angle sensor reading /
      min.: -49152°
      max. 49150.5°
      Actual steering angle
      Left turn: reading increases
      Right turn: reading decreases
      -
      Engine Speed Cam position sensor reading /
      min.: 0 rpm
      max.: 25,500 rpm
      Actual engine speed Speed indicated on the combination meter
      Damper Step FR Damper step (Front RH) /
      min.: 0 step
      max.: 255 step
      min.: 1 step
      max.: 17 step
      -
      Damper Step FL Damper step (Front LH) /
      min.: 0 step
      max.: 255 step
      min.: 1 step
      max.: 17 step
      -
      Damper Step RR Damper step (Rear RH) /
      min.: 0 step
      max.: 255 step
      min.: 1 step
      max.: 17 step
      -
      Damper Step RL Damper step (Rear LH) /
      min.: 0 step
      max.: 255 step
      min.: 1 step
      max.: 17 step
      -
      Max Damper Step FR Damper step (Front LH) /
      min.: 0 step
      max.: 255 step
      17 step -
      Max Damper Step FL Damper step (Front LH) /
      min.: 0 step
      max.: 255 step
      17 step -
      Max Damper Step RR Damper step (Rear RH) /
      min.: 0 step
      max.: 255 step
      17 step -
      Max Damper Step RL Damper step (Rear LH) /
      min.: 0 step
      max.: 255 step
      17 step -
      Number of Trouble Codes Number of DTC recorded/
      min.: 0
      max.: 255
      0 -
    5. Enter the following menus: Body Electrical / Center Console Switch / Data List.
    6. Read the Data List by following the directions on the Techstream screen.

    Center Console Switch 

    DIAGNOSTIC NOTE TABLE

    Tester Display Measurement Item/Range Normal Condition Diagnostic Note
    SPORT Mode Switch Absorber control switch ON or OFF ON: SPORT
    OFF: Normal
    -
    COMFORT Mode Switch Absorber control switch ON or OFF ON: COMFORT
    OFF: Normal
    -
    HEIGHT HIGH Switch Height control switch / ON or OFF ON: Switch is pressed and held
    OFF: Switch is not pressed
    -
  2. PERFORM ACTIVE TEST 

    HINT:

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG) and the Techstream on.
    3. Enter the following menus: Chassis / Air suspension / Active Test.
    4. Perform the Active Test by following the prompts on the Techstream.

      Air suspension 

      DIAGNOSTIC NOTE TABLE

      Tester Display Test Part Control Range Diagnostic Note
      Damper Step FR Changes damper step (Front RH) / min.: 1 step
      max.: 17 step
      Shock absorber hardens as damper step increases
      Damper Step FL Changes damper step (Front LH) / min.: 1 step
      max.: 17 step
      Shock absorber hardens as damper step increases
      Damper Step RR Changes damper step (Rear RH) / min.: 1 step
      max.: 17 step
      Shock absorber hardens as damper step increases
      Damper Step RL Changes damper step (Rear LH) / min.: 1 step
      max.: 17 step
      Shock absorber hardens as damper step increases
      FR Wheel Up/Down Right front vehicle height / UP or DOWN -
      FL Wheel Up/Down Left front vehicle height / UP or DOWN -
      RR Wheel Up/Down Right rear vehicle height / UP or DOWN -
      RL Wheel Up/Down Left rear vehicle height / UP or DOWN -
      Front Right Solenoid Turn OFF front solenoid valve RH 1 second after turning it ON - Operation of solenoid (clicking sound) can be heard
      Front Left Solenoid Turn OFF front solenoid valve LH 1 second after turning it ON - Operation of solenoid (clicking sound) can be heard
      Rear Right Solenoid Turn OFF rear solenoid valve RH 1 second after turning it ON - Operation of solenoid (clicking sound) can be heard
      Rear Left Solenoid Turn OFF rear solenoid valve LH 1 second after turning it ON - Operation of solenoid (clicking sound) can be heard
      Motor Relay Suspension control relay / ON or OFF Operation of solenoid (clicking sound) can be heard
      Exhaust Solenoid Exhaust solenoid / ON or OFF Operation of solenoid (clicking sound) can be heard
    5. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    6. Perform the Active Test by following the prompts on the Techstream.

    Combination Meter 

    DIAGNOSTIC NOTE TABLE

    Tester Display Test Part Control Range Diagnostic Note
    Indicat. TEMS Sports Absorber control indicator light (SPORT)/ ON or OFF -
    Indicat. TEMS Comfort Absorber control indicator light (COMFORT)/ ON or OFF -
    Indicat. Height High Height control indicator light (HEIGHT HIGH)/ ON or OFF -