Height Control Compressor: Installation

INSTALL HEIGHT CONTROL COMPRESSOR
1. Install the 3 bushes and bracket to the height control compressor with the 3 bolts.
  Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf)
2. Push the connector into the housing until a clicking sound is heard.
3. Attach the 3 clamps.
  
  Fig 1: Locating Compressor Bushings And Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the height control compressor with the bolt and 2 nuts
  Torque: 19 N*m (195 kgf*cm, 14 ft.*lbf)
5. Connect the height control tube (Type 2) (see PRECAUTION ).
6. Connect the height control filter to the bumper reinforcement.
  
  Fig 2: Locating Height Control Compressor Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Connect the 2 connectors and attach the 2 clamps.
  
  Fig 3: Locating Connectors And Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
8. Install the fender liner with the 3 screws.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.6 N*m (57 kgf*cm, 50 in.*lbf)

NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).

Fig 4: Locating Fender Liner Screws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION )
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see DIAGNOSIS SYSTEM ).
INSPECT FOR AIR LEAK
1. Inspect for air leak (see OPERATION CHECK ).
INSTALL FRONT BUMPER COVER (See INSTALLATION )
INSTALL FRONT FENDER LINER LH (See INSTALLATION )
INSTALL FRONT FENDER LINER RH (See INSTALLATION )
INSTALL FRONT WHEEL OPENING EXTENSION PAD LH (See REMOVAL )
INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (See INSTALLATION )
INSTALL RADIATOR GRILLE ASSEMBLY (See INSTALLATION )
INSTALL FRONT FENDER WHEEL OPENING MOLDING LH (See INSTALLATION )
INSTALL FRONT FENDER WHEEL OPENING MOLDING RH (See INSTALLATION )
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
INSTALL AIR CLEANER INLET COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
INSTALL FRONT WHEEL RH
Torque: 140 N*m (1428 kgf*cm, 103 ft.*lbf)