Inner Rear View Mirror: Installation

INSTALL INNER REAR VIEW MIRROR ASSEMBLY
1. Using a T20 "TORX" socket wrench, install the inner rear view mirror with the screw
  Torque: 1.8 N*m (18 kgf*cm, 16 in.*lbf)
2. Connect the connector
Fig 1: Identifying Inner Rear View Mirror Screw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RAIN SENSOR COVER (w/ Driver Monitor Camera)
NOTE:
- When installing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".
- When installing the rain sensor cover, apply force to the areas labeled "O" to attach the clips.
Fig 2: Identifying Rain Sensor Cover Camera And Clip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. While being careful not to apply force to the camera areas, attach the 2 claws and 2 clips to install the rain sensor cover.
2. Push the stopper as shown in the illustration to fix the cover in place.
Fig 3: Pushing Stopper
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL RAIN SENSOR COVER
1. Attach the 2 claws to install the rain sensor cover.
2. Push the stopper as shown in the illustration to fix the cover in place.
INSTALL MAP LIGHT ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION )