Inner Rear View Mirror: Removal

REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See COMPONENTS )
REMOVE BATTERY SERVICE HOLE COVER LH (See REMOVAL )
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
REMOVE MAP LIGHT ASSEMBLY (See REMOVAL )
REMOVE RAIN SENSOR COVER
1. Pull the stopper in the direction shown in the illustration.
2. Detach the 2 claws and remove the rain sensor cover
REMOVE RAIN SENSOR COVER (w/ Driver Monitor Camera)
NOTE: When removing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".

Fig 2: Identifying Rain Sensor Cover Camera And Clip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Pull the stopper in the direction shown in the illustration.
2. While being careful not to apply force to the camera areas, detach the 2 clips and 2 claws and remove the rain sensor cover
REMOVE INNER REAR VIEW MIRROR ASSEMBLY
1. Disconnect the connector.
2. Using a T20 "TORX" socket wrench, remove the screw and inner rear view mirror
Fig 4: Identifying Inner Rear View Mirror Screw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002