Charging Systems: Charging: Battery: Installation

INSTALL BATTERY CARRIER
1. Install the battery carrier with the 3 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 1: Locating Battery Carrier With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL BATTERY
1. Install the battery
2. Install the No. 2 battery hold down clamp with the bolt
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 2: Removing/Installing Battery
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the battery clamp with the nut.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
4. Connect the thermistor sensor connector
5. Connect the battery room ventilation hose.
6. Connect the cable to the positive (+) battery terminal.
  Torque: 5.6 N*m (57 kgf*cm, 50 in.*lbf)
7. Connect the cable to the negative (-) battery terminal
  Torque: 5.6 N*m (57 kgf*cm, 50 in.*lbf)
  NOTE:
  - When the warning light is illuminated or the battery has been disconnected and reconnected, turning the power switch may not start the system on the first try. If so, turn the power switch again.
  - When disconnecting the cable, some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
INSTALL BATTERY SERVICE HOLE COVER LH (See INSTALLATION )
INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY (See INSTALLATION )