Heated Oxygen Sensor: Removal

HINT:

When viewed from the rear of the engine assembly, Bank 1 is on the left side and Bank 2 is on the right side.

1. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) 
   1. Disconnect the sensor connector.
   Fig 1: Locating Sensor Connector
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Using SST, remove the sensor from the front exhaust pipe.

      SST 09224-00010 

2. REMOVE FRONT DOOR SCUFF PLATE RH 
   1. Remove the front door scuff plate RH (see REMOVAL )
3. REMOVE COWL SIDE TRIM BOARD RH 
   1. Remove the cowl side trim board RH (see REMOVAL ).
4. REMOVE FRONT FLOOR SILENCER PAD RH 
5. REMOVE REAR NO. 2 AIR DUCT 
6. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) 
   1. Interior Side:

      Disconnect the sensor connector.

      Fig 2: Locating Sensor Connector (Interior Side)

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Exterior Side.
      1. Remove the grommet.
      Fig 3: Locating Sensor Connector (Exterior Side)
      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Using SST, remove the sensor from the front exhaust pipe.

         SST 09224-00010