Service Data

Hydrocarbon adsorber catalyst switching valve

HYDROCARBON ADSORBER CATALYST SWITCHING VALVE - SERVICE DATA

Resistance	1-2	37 to 44 Ω at 20°C (68°F)
Resistance	1 - Body ground 2 - Body ground	1 MΩ or higher
Operation	Battery positive (+) → Terminal 2 Battery negative (-) → Terminal 1	Air flows from port E to port F

Hydrocarbon adsorber catalyst actuator

HYDROCARBON ADSORBER CATALYST ACTUATOR - SERVICE DATA

Operation

When a vacuum of 27 kPa (203 mmHg, 7 97 in Hg) is applied to the diaphragm chamber

The shaft moves with no abnormal noise and that the retainer contacts the stopper

Canister

CANISTER - SERVICE DATA

Operation	Purge port → Close Vent port → Apply 1 kPa (10.1gf/cm² , 0.1 psi) of air	Air flows from the air inlet port
Operation	Vent port → Close Air inlet port → Apply 1 kPa (10.1gf/cm² , 0.1 psi) of air	Air flows from the purge port
Air leakage	With the purge port and air inlet port closed Vent port → Apply 20 kPa (0.2 kgf/cm² , 2.9 psi) of pressurized air	Confirm that pressure is retained for 1 minute

Leak detection pump

LEAK DETECTION PUMP - SERVICE DATA

Operation	Air inlet port (A) → Apply air	Air flows from port B and then to C
Operation	Battery positive (+) → Terminal 7 Battery negative (-) → Terminal 6	Detention pump's valve is close

Purge VSV

PURGE VSV - SERVICE DATA

Resistance	1-2	23 to 26 Ω at 20°C (68°F)
Resistance	1 - Body ground 2 - Body ground	10 MΩ or higher at always
Operation	Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 2	Air flows form port E to port F

Exhaust gas temperature sensor

EXHAUST GAS TEMPERATURE SENSOR - SERVICE DATA

Resistance	1-2	7 72 kΩ or higher at 20°C (68°F)
	3-4

Fuel vapor containment valve

FUEL VAPOR CONTAINMENT VALVE - SERVICE DATA

Resistance

1-2

25 to 30 Ω at 20°C (68°F)