How To Proceed With Troubleshooting

HINT:

• Use these procedures to troubleshoot the active stabilizer suspension system.
• *. Using the Intelligent tester or Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT AUXILIARY BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the auxiliary battery before proceeding

3. CHECK FOR DTC (ALL)* 
   1. Check for all DTCs.

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC is output	A
      CAN communication system DTC is output	B
      DTC is not output	C

      If a CAN communication malfunction code is output, troubleshoot that code before performing repairs on this system

   B: GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)  (see HOW TO PROCEED WITH TROUBLESHOOTING )

   C: USE SIMULATION METHOD TO CHECK  (see HOW TO PROCEED WITH TROUBLESHOOTING )

   A: Go to next Step 

4. REPAIR OR REPLACE 
   1. Before performing repairs or replacement, refer to PRECAUTION  .
   2. Refer to the DIAGNOSTIC TROUBLE CODE CHART  and perform repairs .
5. CONFIRMATION TEST* 
   1. Perform the OPERATION CHECK  .

   NEXT: END