Inspection Procedure

1. Remove the ECU-IG No. 3 fuse from the cowl side junction block RH.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   ECU-IG No. 3 fuse	Always	Below 1 Ω

NG: REPLACE FUSE 

OK: Go to next step 

1. Disconnect the E86 distance control ECU connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage 

   STANDARD VOLTAGE SPECIFICATION
   
   

   Tester Connection	Switch Condition	Specified Condition
   E86-1 (B) - Body ground	Engine switch on (IG)	11 to 14 V
   	Engine switch off	Below 1 V

3. Measure the resistance according to the value(s) in the table below.
   Fig 1: Identifying E86 Distance Control ECU Connector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance 

   STANDARD RESISTANCE SPECIFICATION
   
   

   Tester Connection	Condition	Specified Condition
   E86-12 (GND) - Body ground	Always	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE  )