Inspection Procedure

1. Using the standard operation procedure, check that the wireless door lock/unlock operates normally.

   OK: Wireless door lock/unlock operates normally. 

   HINT:

   The standard operating procedure is as follows: Hold the transmitter approximately 1 m (3.28 ft.) from the driver door outside handle. Press and hold the transmitter lock or unlock switch for 1 second.

NG: GO TO WIRELESS DOOR LOCK CONTROL SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

OK: Go to Next Step 

1. Using the standard operation procedure, check that the power door lock/unlock operates normally.

   OK: Power door lock/unlock operates normally. 

NG: GO TO POWER DOOR LOCK CONTROL SYSTEM  (See HOW TO PROCEED WITH TROUBLESHOOTING )

OK: Go to Next Step 

1. Perform a memory operation properly. Check that the buzzer sounds to indicate the completion of the memory operation.
   NOTE:

   • The seat position will not be recorded if the seat memory SET switch and 2 or more of the seat memory switches (for example, seat memory switch 1 and seat memory switch 2) are pressed simultaneously.
   • If a memorizing operation has failed, release all switches. The seat memory function does not operate unless the switches are released.

   OK: Seat memory switch function operates normally. 

NG: GO TO PROBLEM SYMPTOMS TABLE  (See )

OK: Go to Next Step 

1. While pressing seat memory switch 1, seat memory switch 2 or seat memory switch 3 switch, press the transmitter lock or unlock switch. Then check that the buzzer sounds normally.

   OK: Buzzer sounds normally. 

NG: REPLACE POSITION CONTROL ECU AND SWITCH  (See REMOVAL  )

OK: END