April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

NOTE: When replacing the master cylinder solenoid, perform zero point calibration (See CALIBRATION ).

CHECK CAN COMMUNICATION LINE
1. Turn the engine switch off.
2. Connect the Techstream to the DLC3.
3. Turn the engine switch on (IG) and the Techstream on.
4. Select "CAN Bus Check" from the System Selection Menu screen, and follow the prompts on the screen to inspect the CAN Bus.
OK: "CAN Bus Check" indicates no malfunctions in CAN communication.

NG: GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (See SYSTEM DESCRIPTION )

OK: Go to next step

CHECK DTC (for CAN Communication System)

Turn the engine switch off.
Connect the Techstream to the DLC3.
Turn the engine switch on (IG) and the Techstream on.
Check for DTCs (See HOW TO PROCEED WITH TROUBLESHOOTING ).

Result

RESULT REFERENCE

Result	Proceed to
CAN system DTC is not output.	A
CAN system DTC is output.	B

B: GO TO CAN COMMUNICATION SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (See DIAGNOSTIC TROUBLE CODE CHART )

A: GO TO TRANSFER SYSTEM (INSPECTION) (See INSPECTION )