Oil Level Sensor: Removal

REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (See REMOVAL )
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (See REMOVAL )
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 2 ENGINE UNDER COVER (See REMOVAL )
DRAIN ENGINE OIL (See REPLACEMENT )
DISCONNECT OIL COOLER PIPE ASSEMBLY
1. Remove the 2 bolts and disconnect the oil cooler pipe.
REMOVE ENGINE OIL LEVEL SENSOR
1. Disconnect the oil level sensor connector.
  
  Fig 1: Locating Oil Cooler Pipe Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 4 bolts and oil level sensor.
  
  Fig 2: Locating Oil Level Sensor Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Cut off the gasket as shown in the illustration.
4. Remove the gasket from the oil level sensor.
  HINT:
  
  After cutting away the parts of the gasket shown in the illustration, remove only the outer part of the gasket.
  
  Fig 3: Identifying Gasket Cutting Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002