Oil Pressure Sensor: Installation

INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY
1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.
  Adhesive:
  
  Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
  
  Fig 1: Applying Adhesive To Threads Of Oil Pressure Sender Gauge
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: Do not allow adhesive to contact the oil hole.
  
  Fig 2: Identifying Oil Hole
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the oil pressure sender gauge.
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  
  NOTE: Do not start the engine within 1 hour after installation.
  
  Fig 3: Locating Oil Pressure Sender Gauge
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the sender gauge connector.
ADD ENGINE OIL (See REPLACEMENT )
INSPECT FOR OIL LEAK (See REPLACEMENT )
INSPECT ENGINE OIL LEVEL (See ON-VEHICLE INSPECTION )
INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (See INSTALLATION )

Fig 4: Locating Sender Gauge Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002