Fuel Pump: Reassembly
NOTE:
Do not disconnect the hoses indicated in the illustration.
- INSTALL NO. 1 FUEL SUCTION SUPPORT
- Attach the 2 claws to the claw holes to install the fuel suction support.
- INSTALL FUEL MAIN VALVE ASSEMBLY
- Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve.
- Install the fuel main valve to the fuel filter case.NOTE: Make sure the O-rings are not cut or pinched during the installation.
- INSTALL FUEL PUMP
- Connect the fuel pump wire harness connector to the fuel pump.
- Apply a light coat of gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.
- Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.
- INSTALL NO. 1 FUEL SUB-TANK NOTE: Make sure that the fuel tube passes into the section marked by the circle.
- Attach the 3 claws to the claw holes to install the fuel sub-tank.
- Attach the 3 claws to the claw holes.
- Install the tube part to the sub-tank.
- Attach the claw on the end of the tube to the claw hole. Install the tube to the 2 clamps on the sub-tank.
- Connect the jet pump to the sub-tank.
- Connect the fuel pump connector.
- INSTALL FUEL SENDER GAUGE ASSEMBLY (See INSTALLATION )