Power Steering Oil Pressure Switch: Installation

INSTALL POWER STEERING OIL PRESSURE SWITCH
1. Install a new O-ring to the oil pressure switch.
2. Apply a light coat of engine oil to the O-ring of the oil pressure switch.
  NOTE:
  - When reusing the oil pressure switch, inspect the O-ring.
  - If the O-ring has scratches or cuts, replace the oil pressure switch.
3. Using a 24 mm deep socket wrench, install the oil pressure switch.
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
4. Connect the oil pressure switch connector.
Fig 1: Locating Power Steering Oil Pressure Switch
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY RH
1. Install the sensor with the bolt and nut.
  Torque: for bolt
  
  13 N*m (127 kgf*cm, 9 ft.*lbf)
  
  for nut
  
  5.6 N*m (57 kgf*cm, 50 in.*lbf)
2. Connect the connector.
INSTALL FAN AND GENERATOR V BELT (See INSTALLATION )
INSTALL AIR CLEANER ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER HOSE ASSEMBLY (See INSTALLATION )

Fig 2: Locating Front Height Control Sensor Connector And Bolt
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
ADD POWER STEERING FLUID
BLEED POWER STEERING FLUID (See ON-VEHICLE INSPECTION )
INSPECT FOR POWER STEERING FLUID LEAK
INSTALL FRONT FENDER APRON SEAL FRONT RH (See INSTALLATION )
INSTALL FRONT WHEEL (See INSTALLATION )
INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
PERFORM VEHICLE HEIGHT OFFSET CALIBRATION (See INSTALLATION )
ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY (See ADJUSTMENT )
PERFORM ZERO POINT CALIBRATION OF G SENSOR (See INSTALLATION )
ADJUST HEADLIGHT ASSEMBLY (See INSTALLATION )
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL UPPER RADIATOR SUPPORT SEAL (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER RH (See INSTALLATION )
INSTALL ENGINE ROOM SIDE COVER LH (See INSTALLATION )