Torque Specifications
Oil and Oil Filter
OIL AND OIL FILTER TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Oil pan drain plug x No. 2 oil pan | 40 | 408 | 30 |
| Oil filter cap x Oil filter bracket | 25 | 255 | 18 |
| Oil filter drain plug x Oil filter cap | 13 | 127 | 9 |
| No. 2 engine under cover seal x No. 2 engine under cover | 10 | 102 | 7 |
Oil Pressure Sensor
OIL PRESSURE SENSOR TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Oil pressure sender gauge x Oil filter bracket | 15 | 153 | 11 |
Oil Level Sensor
OIL LEVEL SENSOR TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Oil cooler pipe x No. 1 oil pan and bracket | 14 | 143 | 10 |
| Engine oil level sensor x No. 1 oil pan | 7.0 | 71 | 62 in.*lbf |
Oil Pump
OIL PUMP TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf | |
|---|---|---|---|---|
| Relief valve plug x Oil pump cover | 53 | 540 | 39 | |
| Oil pump cover x Timing chain cover | 10 | 105 | 8 | |
| Timing chain cover x Cylinder block and cylinder head | for bolt A, B, C, nut | 23 | 235 | 17 |
| for bolt D, E, F | 47 | 479 | 35 | |
| Cylinder head cover LH x Camshaft housing LH and timing chain cover | for bolt A | 21 | 214 | 15 |
| except bolt A | 12 | 122 | 9 | |
| Cylinder head cover RH x Camshaft housing RH and timing chain cover | for bolt A | 21 | 214 | 15 |
| except bolt A | 12 | 122 | 9 | |
| Cylinder head cover RH x Noise filter | 7.0 | 71 | 62 in.*lbf | |
| Ignition coil x Cylinder head cover | 10 | 102 | 7 | |
| Crankshaft pulley x Crankshaft | 300 | 3059 | 221 | |
| Wire harness clamp bracket x Timing chain cover | 8.0 | 82 | 71 in.*lbf | |
| No. 1 idler pulley x Timing chain cover | 43 | 438 | 32 | |
| Water pump pulley x Water pump | 21 | 214 | 15 | |
| Water inlet housing x Timing chain cover | 21 | 214 | 15 | |
| Air tube x Cylinder block and timing chain cover | 10 | 102 | 7 | |
| Front water by-pass joint x Cylinder head | 21 | 214 | 15 | |
| Water by-pass pipe x Cylinder head cover and timing chain cover | 10 | 102 | 7 | |
| Vane pump x Cylinder head | 21 | 214 | 15 | |
| Oil filter bracket x Timing chain cover | 35 | 357 | 26 | |
| No. 2 water by-pass pipe sub-assembly x Timing chain cover and front water by-pass joint | 10 | 102 | 7 | |
| No. 2 fuel tube x Cylinder head cover | 10 | 102 | 7 | |
| Cooler compressor x Timing chain cover and Cylinder block | for stud bolt | 10 | 102 | 7 |
| for bolt and nut | 25 | 250 | 18 | |
| No. 2 water by-pass pipe x Cylinder head cover RH and Automatic transmission | 18 | 184 | 13 | |
| Ground wire x Body | 8.0 | 82 | 71 in.*lbf | |
Engine Oil Cooler
ENGINE OIL COOLER TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf |
|---|---|---|---|
| Relief valve plug x Oil filter bracket | 37 | 375 | 27 |
| Oil cooler spacer x Oil filter bracket | 10 | 102 | 7 |
| Oil cooler x Oil filter bracket | 21 | 214 | 15 |
| Oil filter bracket x Timing chain cover | 35 | 357 | 26 |
| No. 1 oil cooler bracket x Oil filter bracket and No. 1 oil pan | 21 | 214 | 15 |
| No. 2 water by-pass hose x Timing chain cover | 10 | 102 | 7 |