Front Seat Inner Belt Assembly: Removal

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
   NOTE:

   • w/ Navigation System:

     After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

   • When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
2. REMOVE FRONT SEAT ASSEMBLY 
   1. Remove the front seat assembly (See REMOVAL ).
3. REMOVE FRONT SEAT INNER BELT ASSEMBLY 
   1. Disconnect the 3 connectors and detach the clamps
   2. Remove the nut and front seat inner belt assembly.
      Fig 1: Removing Front Seat Inner Belt Assembly

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002