Height Control Accumulator: Installation

INSTALL SUSPENSION CONTROL PUMP ACCUMULATOR ASSEMBLY
1. Install the accumulator with the 3 nuts.
  Torque: 31 N*m (316 kgf*cm, 23 ft.*lbf)
Fig 1: Locating Suspension Control Pump Accumulator Nuts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 7 HEIGHT CONTROL TUBE
1. Using a union nut wrench, install the No. 7 control tube to the control valve and accumulator.
  Torque: without union nut wrench
  
  15 N*m (155 kgf*cm, 11 ft.*lbf)
  
  with union nut wrench
  
  14 N*m (143 kgf*cm, 10 ft.*lbf)
  
  HINT:
  - Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).
  - The torque value for use with a union nut wrench is effective when the union nut wrench is parallel to the torque wrench.
  Fig 2: Installing No. 7 Control Tube To Control Valve And Accumulator
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CENTER EXHAUST PIPE ASSEMBLY (See INSTALLATION )
INSTALL TAILPIPE ASSEMBLY (See INSTALLATION )
BLEED AIR FROM SUSPENSION FLUID (See BLEEDING )
CHECK FLUID LEVEL IN RESERVOIR (See ON-VEHICLE INSPECTION )
INSPECT FOR SUSPENSION FLUID LEAK (See ON-VEHICLE INSPECTION )
INSTALL HEIGHT CONTROL UNIT INSULATOR (See HEIGHT CONTROL ACCUMULATOR )
CHECK FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.