Suspension Control Ecu: Installation

INSTALL SUSPENSION CONTROL ECU
1. Attach the wire harness clamp and connect the connector.
2. Install the ECU with the 2 bolts.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  Fig 1: Locating Suspension Control ECU Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR SIDE NO. 2 AIR DUCT (See INSTALLATION )
INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH (See INSTALLATION )
INSTALL REAR SEAT COVER CAP (for Semi Power Seat) (See INSTALLATION )
INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (See INSTALLATION )
INSTALL REAR FLOOR MAT REAR SUPPORT PLATE (See INSTALLATION )
INSTALL REAR DOOR SCUFF PLATE LH (See INSTALLATION )
INSTALL REAR STEP COVER (See INSTALLATION )
INSTALL REAR NO. 2 SEAT ASSEMBLY LH
1. w/ Manual Folding-up Function:
  Install the rear No. 2 seat assembly LH (See INSTALLATION ).
2. w/ Automatic Folding-up Function:
  Install the rear No. 2 seat assembly LH (See INSTALLATION ).
INSTALL REAR NO. 2 SEAT ASSEMBLY RH
HINT:

Use the same procedures described for the LH side.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
1. Perform the vehicle height offset calibration (See INITIALIZATION ).
PERFORM ZERO POINT CALIBRATION OF G SENSOR
1. Perform the zero point calibration of the G sensor (See CALIBRATION ).
ADJUST HEADLIGHT ASSEMBLY
1. Adjust the headlight (See ADJUSTMENT ).