Transmission Wire: Installation

INSTALL TRANSMISSION WIRE
1. Coat the O-ring of the transmission wire connector with ATF.
2. Install the 2 transmission wires with the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 1: Locating Transmission Wires Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the 2 transmission wire connectors.
HINT:

Push up the lever until the claw of the transmission wire connector makes a connection sound.

Fig 2: Locating Transmission Wire Connectors
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION WIRE
1. Connect the 9 connectors to the solenoid valves.
2. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.
  Torque: for bolt A
10 N*m (102 kgf*cm, 7 ft.*lbf)

for bolt B

11 N*m (112 kgf*cm, 8 ft.*lbf)

HINT:

Each bolt length is indicated below.

12 mm (0.472 in.) for bolt A

36 mm (1.41 in.) for bolt B

Fig 3: Identifying ATF Temperature Sensors With Clamps And Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL VALVE BODY OIL STRAINER ASSEMBLY
1. Coat a new O-ring with ATF and install it to the oil strainer.
2. Install the oil strainer with the 4 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Fig 4: Locating Oil Strainer Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
1. Install the 4 transmission oil cleaner magnets to the oil pan.
  
  Fig 5: Installing Transmission Oil Cleaner Magnets To Oil Pan
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install a new gasket and the oil pan with the 12 bolts.
  Torque: 7.4 N*m (75 kgf*cm, 65 in.*lbf)
Fig 6: Locating Oil Pan Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:
- Make sure that there is no oil or foreign matter on the gasket seal surface and oil pan contact surface.
- Install the gasket so that there is no slack in the gasket, and make sure the entire circumference of the seal surface is level.
- Make sure that the 9 gasket drop prevention protrusions are set on the oil pan.
- When tightening the bolts of the oil pan, make sure that the gasket is not pinched between the gasket tightening area sleeve and the transmission seal surface.
Fig 7: Identifying Correct Installation Of Sleeve
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD AUTOMATIC TRANSMISSION FLUID
1. Add automatic transmission fluid (See AUTOMATIC TRANSMISSION FLUID ).
INSTALL OIL PAN PROTECTOR ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 ENGINE UNDER COVER (See AUTOMATIC TRANSMISSION UNIT )