Valve Body Assembly: Installation

INSTALL TRANSMISSION VALVE BODY ASSEMBLY
1. Install the spring and check ball body.
  
  Fig 1: Installing Spring And Check Ball Body
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert the pin of the manual valve into the hole of the manual valve lever.
  
  Fig 2: Inserting Pin Of Manual Valve Into Hole Of Manual Valve Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 19 bolts.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
  
  HINT:
  
  Each bolt length is indicated below.
  
  36 mm (1.42 in.) for bolt A
  
  25 mm (0.984 in.) for bolt B
  
  45 mm (1.77 in.) for bolt C
  
  50 mm (1.97 in.) for bolt D
4. Install the detent spring and detent spring cover with the bolt.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
Fig 3: Identifying Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT TRANSMISSION WIRE (See INSTALLATION )
INSTALL VALVE BODY OIL STRAINER ASSEMBLY (See INSTALLATION )
INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
ADD AUTOMATIC TRANSMISSION FLUID
1. Add automatic transmission fluid (See AUTOMATIC TRANSMISSION FLUID ).
INSTALL OIL PAN PROTECTOR ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 ENGINE UNDER COVER (See AUTOMATIC TRANSMISSION UNIT )