Ignition Coil: Installation

INSTALL IGNITION COIL ASSEMBLY

Fig 1: Locating Ignition Coils & Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the 6 ignition coils with the 6 bolts.
  Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf)
2. Connect the 6 ignition coil connectors.
INSTALL NO. 1 SURGE TANK STAY
1. Install the No. 1 surge tank stay with the bolt.
  Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf)
  
  Fig 2: Locating Bolt & No. 1 Surge Tank Stay
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the bolt and clamp.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
  
  Fig 3: Locating Bolt & Harness Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INTAKE AIR SURGE TANK ASSEMBLY (See INSTALLATION )
INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See INSTALLATION )
INSTALL COWL TOP PANEL OUTER SUB-ASSEMBLY (See INSTALLATION )
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
(See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (See INSTALLATION )
ADD ENGINE COOLANT (See ON-VEHICLE INSPECTION )
CHECK FOR ENGINE COOLANT LEAKS (See ON-VEHICLE INSPECTION )
INSTALL NO. 1 ENGINE UNDER COVER
INSTALL V-BANK COVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL ENGINE ROOM COVER SIDE (See INSTALLATION )
PERFORM INITIALIZATION
1. Perform initialization procedure (See INITIALIZATION ).
  HINT:
  
  Some systems need initialization after reconnecting the cable to the negative battery terminal.