Height Control Valve: Installation

INSTALL HEIGHT CONTROL VALVE SUB-ASSY NO.1
1. Install the height control valve sub-assembly No.1 with the 2 nuts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 1: Identifying Nuts On Height Control Valve Sub-Assembly No.1
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Coat 2 new O-rings with MP grease No.2 and install them on each height control tube.
3. Connect the 3 height control tubes onto the height control valve sub-assembly No.1.
  
  Fig 2: Identifying Height Control Tubes & Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  For the removal procedure of the (type 3) tube, refer to PRECAUTION .
4. Connect the connector.
INSPECT AIR LEAK
INSTALL FRONT BUMPER COVER
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSY LH
INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSY RH
INSTALL ENGINE UNDER COVER NO.1
INSTALL HEIGHT CONTROL VALVE SUB-ASSEMBLY NO.2
1. Install the height control valve sub-assembly No.2 with the 2 nuts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
  
  Fig 3: Identifying Nuts On Height Control Valve Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Coat the O-ring with MP grease.
3. Install the O-ring onto the height control tube.
  
  Fig 4: Identifying O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the height control tube.
  HINT:
  
  For the removal procedure of the (type 3) tube, refer to PRECAUTION .
5. Install 6 new O-ring and 3 new plates to each installed part of the height control valve No.2 tube.
  HINT:
  
  When the height control valve No.2 is replaced with a new one, it does not require a new O-ring.
6. Install the 3 height control tubes.
  
  Fig 5: Identifying Connector & Height Control Tubes
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  For the removal procedure of the (type 2) tube, refer to PRECAUTION .
7. Connect the connector.
INSPECT AIR LEAK