LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> RX 350 FWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Vehicle Stability Control System >> Data List / Active Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test

  1. DATA LIST 

    HINT:

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the intelligent tester to the DLC3.
    4. Turn the ignition switch to the ON position.
    5. Turn the intelligent tester on.
    6. Enter the following menus: DIAGNOSIS / OBD/ MOBD / ABS/VSC / DATA LIST.
    7. According to the display on the tester, perform the Data List.

      DATA LIST: 

      NORMAL CONDITION CHART

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      ABS MOT RELAY ABS motor relay / ON or OFF ON: Motor relay ON -
      SOL RELAY Solenoid relay / ON or OFF ON: Solenoid relay ON -
      VSC / TRC OFF SW VSC OFF switch / ON or OFF ON: VSC OFF switch OFF
      OFF: VSC OFF switch ON      		 -
      IDLE SW Main idle switch / ON or OFF ON: Accelerator pedal released
      OFF: Accelerator pedal depressed      		 -
      STOP LIGHT SW Stop light switch / ON or OFF ON: Brake pedal depressed
      OFF: Brake pedal released      		 -
      PKB SW Parking brake switch / ON or OFF ON: Parking brake applied
      OFF: Parking brake released      		 -
      STEP FORCE SW Brake pedal load sensing switch / ON or OFF ON: Brake pedal depressed beyond the specified point
      OFF: Brake pedal not depressed beyond the specified point      		 -
      ABS OPERT FR ABS operation (FR) / BEFORE or OPERATE BEFORE: No ABS operation (FR)
      OPERATE: During ABS operation (FR)      		 -
      ABS OPERT FL ABS operation (FL) / BEFORE or OPERATE BEFORE: No ABS operation (FL)
      OPERATE: During ABS operation (FL)      		 -
      ABS OPERT RR ABS operation (RR) / BEFORE or OPERATE BEFORE: No ABS operation (RR)
      OPERATE: During ABS operation (RR)      		 -
      ABS OPERT RL ABS operation (RL) / BEFORE or OPERATE BEFORE: No ABS operation (RL)
      OPERATE: During ABS operation (RL)      		 -
      WHEEL SPDFR Wheel speed sensor (FR) reading / min.: 0 MPH (0 km/h, max.: 202 MPH (326 km/h) Actual wheel speed Similar speed as indicated on speedometer
      WHEEL SPD FL Wheel speed sensor (FL) reading / min.: 0 MPH (0 km/h, max.: 202 MPH (326 km/h) Actual wheel speed Similar speed as indicated on speedometer
      WHEEL SPD RR Wheel speed sensor (RR) reading / min.: 0 MPH (0 km/h, max.: 202 MPH (326 km/h) Actual wheel speed Similar speed as indicated on speedometer
      WHEEL SPD RL Wheel speed sensor (RL) reading / min.: 0 MPH (0 km/h, max.: 202 MPH (326 km/h)) Actual wheel speed Similar speed as indicated on speedometer
      DECELERAT SENS Acceleration sensor 1 reading / min.: -1.869 G, max.: 1.869 G Approximately 0 +- 0.13G at still condition Reading changes when vehicle is tilted
      DECELERAT SENS2 Acceleration sensor 2 reading / min.: -1.869 G, max.: 1.869 G Approximately 0 +- 0.13G at still condition Reading changes when vehicle is tilted
      IG VOLTAGE ECU power supply voltage / NORMAL / TOO LOW NORMAL: 9.5 V to 16.5 V
      TOO LOW: Below 9.5 V      		 -
      SFRR ABS solenoid (SFRR) / ON or OFF ON: Operates -
      SFRH ABS solenoid (SFRH) / ON or OFF ON: Operates -
      SFLR ABS solenoid (SFLR) / ON or OFF ON: Operates -
      SFLH ABS solenoid (SFLH) / ON or OFF ON: Operates -
      SRRR (SRR) ABS solenoid (SRRR (SRR)) / ON or OFF ON: Operates -
      SRRH (SRH) ABS solenoid (SRRH (SRH)) / ON or OFF ON: Operates -
      SRLR ABS solenoid (SRLR) / ON or OFF ON: Operates -
      SRLH ABS solenoid (SRLH) / ON or OFF ON: Operates -
      SMF (BA-SOL) Master cut solenoid (SMF) / ON or OFF ON: Operates -
      SMR Master cut solenoid (SMR) / ON or OFF ON: Operates -
      ENGINE SPD Engine Speed/ Min.: 0 rpm, Max.: 6000 rpm Actual engine speed -
      VEHICLE SPD Wheel speed sensor reading / min.: 0 MPH (0 km/h), max.: 202 MPH (326 km/h) Actual vehicle speed Speed indicated on speedometer
      YAW RATE Yaw rate sensor/ Min.: -128 deg/ s, Max.: 127 deg/s Min.: -128 deg/s
      Max.: 127 deg/s      		 -
      YAW ZERO VALUE Memorized zero value/ Min.: -128 deg/s, Max.: 127 deg/s Min.: -128 deg/s
      Max.: 127 deg/s      		 -
      STEERING ANG Steering angle sensor/ Min.: -1,152 deg, Max.: 1,150.875 deg Left turn: Increase
      Right turn: Decrease      		 -
      MAS CYL PRS 1 Master cylinder pressure sensor 1 reading / min.: 0 V, max.: 5 V When brake pedal is released : 0.3 to 0.9 V Reading increases when brake pedal is depressed
      SPD SEN FR FR speed sensor open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      SPD SEN FL FL speed sensor open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      SPD SEN RR RR speed sensor open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      SPD SEN RL RL speed sensor open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      EFI COM EFI communication open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      YAWRATE SEN Yaw rate sensor open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      DECELE SEN Acceleration sensor open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      STEERING SEN Steering angle sensor open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      M/C SEN 1 Master cylinder pressure sensor 1 open detection / OPN_DET or NORMAL OPN_DET: Momentary interruption
      NORMAL: Normal      		 -
      ACCELERATOR % The difference of a present accelerator / min.: 0 %, max.: 128% Min.: 0%
      Max.: 128%      		 -
      TORQUE Real engine torque/ min.: -1,024 N*m, max.: 1,016 N*m Min.: -1,024 N*m
      Max.: 1,016 N*m      		 -
      TEST MODE Test mode operation / NORMAL or TEST NORMAL: Normal mode
      TEST: During test mode      		 -
      #CODES Number of DTC recorded / min.: 0, max.: 255 Min.: 0
      Max.: 42      		 -
  2. ACTIVE TEST: 

    HINT:

    Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts to operate without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the intelligent tester to the DLC3.
    4. Turn the ignition switch to the ON position.
    5. Turn the intelligent tester on.
    6. Enter the following menus: DIAGNOSIS / OBD/ MOBD / ABS/VSC / ACTIVE TEST.
    7. According to the display on the tester, perform the Active Test.

      ACTIVE TEST 

      CONTROL RANGE REFERENCE

      Tester Display Test Part Control Range Diagnostic Note
      SFRR ABS solenoid (SFRR) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SFRH ABS solenoid (SFRH) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SFLR ABS solenoid (SFLR) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SFLH ABS solenoid (SFLH) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SRRR ABS solenoid (SRRR) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SRRH ABS solenoid (SRRH) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SRLR ABS solenoid (SRLR) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SRLH ABS solenoid (SRLH) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SMF (BA-SOL) Master cut solenoid (SMF (BA-SOL)) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SMR Master cut solenoid (SMR) Solenoid ON / OFF Operation of solenoid (clicking sound) can be heard
      SFRR & SFRH ABS solenoids (SFRR and SFRH) Solenoids ON / OFF Operation of solenoid (clicking sound) can be heard
      SFLR & SFLH ABS solenoids (SFLR and SFLH) Solenoids ON / OFF Operation of solenoid (clicking sound) can be heard
      SRH & SRR ABS solenoids (SRH and SRR) Solenoids ON / OFF Operation of solenoid (clicking sound) can be heard
      SRLR & SRLH ABS solenoids (SRLR and SRLH) Solenoids ON / OFF Operation of solenoid (clicking sound) can be heard
      SFRH & SFLH ABS solenoids (SFRH and SFLH) Solenoids ON / OFF Operation of solenoid (clicking sound) can be heard
      SOL RELAY ABS solenoid relay Relay ON / OFF Operation of solenoid (clicking sound) can be heard
      ABS MOT RELAY ABS motor relay Relay ON / OFF Operation of motor (clicking sound) can be heard
      ABS WARN LIGHT ABS warning light Warning light ON / OFF Observe combination meter
      VSC / TRC OFF IND VSC OFF indicator light Indicator light ON / OFF Observe combination meter
      SLIP INDI LIGHT SLIP indicator light Indicator light ON / OFF Observe combination meter
      BRAKE WRN LIGHT Brake warning light Warning light ON / OFF Observe combination meter
      VSC / BR WARN BUZ Skid control buzzer Buzzer ON / OFF Buzzer sound can be heard
scientia non olet · About LEMON Manuals