Height Control Compressor: Removal

NOTE: Before disconnecting the air tube, press the height control OFF switch to stop the vehicle height control operation.

REMOVE HEIGHT CONTROL COMPRESSOR COVER
1. Remove the 2 screws, the bolt, the clip and the height control compressor cover.
DISCONNECT HEIGHT CONTROL TUBE NO.2
1. Remove the clip and holder.
  
  Fig 1: Identifying Height Control Tube With Clip & Holder
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the height control tube No. 2 from the 2 way cap.
  HINT:
  
  For the disconnecting procedure of the (type 3) tube, refer to PRECAUTION ).
REMOVE REAR HEIGHT CONTROL COMPRESSOR BRACKET
1. Remove the 3 clamps and disconnect the 2 connectors and wire harness.
  
  Fig 2: Identifying Connectors & Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the clamp.
3. Disconnect the hose from the cap grommet.
  
  Fig 3: Identifying Cap Grommet Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Remove the 3 bolts.
  
  Fig 4: Identifying Rear Height Control Compressor Bracket With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Slide the rear height control compressor bracket to the front of the vehicle, and release the claws A and B from the height control compressor bracket.
6. Remove the rear height control compressor w/ bracket assembly.
  
  Fig 5: Identifying Rear Height Control Compressor With Bracket Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE HEIGHT CONTROL FILTER
1. Remove the clamp, 2 clips and 2 hoses.
2. Remove the height control filter.
REMOVE REAR HEIGHT CONTROL COMPRESSOR BRACKET
1. Remove the 3 clamps.
  
  Fig 6: Identifying Rear Height Control Compressor Bracket With Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 3 bolts and the 3 height control compressor bush No. 2 from the rear height control compressor bracket.
REMOVE HEIGHT CONTROL DRYER ASSEMBLY
1. Remove the clip and holder.
2. Remove the height control tube No. 2 from the height control dryer assembly.
  
  Fig 7: Identifying Height Control Tube
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the bolt and the height control dryer assembly from the height control compressor assembly.
  
  Fig 8: Identifying Bolt On Height Control Dryer Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE HEIGHT CONTROL COMPRESSOR ASSEMBLY
1. Remove the O-ring.
  
  Fig 9: Identifying O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  When the height control compressor assembly is replaced with a new one, it doesn't require a new O-ring.