Inspection Procedure

1. Remove the power window motor.
2. Apply battery voltage to the motor connector according to the table below.
   NOTE: Do not apply battery to any terminals except terminals 1 and 2.

   Standard 

   MEASUREMENT CONDITION SPECIFIED CONDITION REFERENCE CHART
   
   

   Measurement Condition	Specified Condition
   Battery positive (+) → Terminal 1 (D) Battery negative (-) → Terminal 2 (U)	Motor gear rotates clockwise
   Battery positive (+) → Terminal 2 (U) Battery negative (-) → Terminal 1 (D)	Motor gear rotates counterclockwise

   Fig 1: Inspecting Power Window Regulator Motor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPLACE POWER WINDOW REGULATOR MOTOR 

OK: Go to next step 

1. Disconnect the P22 and P23 connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION REFERENCE CHART
   
   

   Tester Connection	Condition	Specified Condition
   P22-1 (UP) - P23-2 (U)	Always	Below 1 Ω
   P22-11 (DN) - P23-1 (D)	Always	Below 1 Ω
   P22-1 (UP) - Body ground	Always	10 kΩ or higher
   P22-11 (DN) - Body ground	Always	10 kΩ or higher

Fig 2: Identifying P22 And P23 Connector Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE