LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> RX 400h AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Brake Control Power Supply >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Control Power Supply: Removal

  1. REMOVE DECK BOARD SUB-ASSEMBLY  (See REMOVAL )
  2. REMOVE DECK FLOOR BOX FRONT  (See REMOVAL )
  3. REMOVE DECK FLOOR BOX REAR  (See REMOVAL )
  4. REMOVE DECK NO.2 BOARD SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE DECK NO.3 BOARD SUB-ASSEMBLY  (See REMOVAL )
  6. REMOVE REAR FLOOR FINISH PLATE  (See REMOVAL )
  7. REMOVE DECK SIDE TRIM BOX RH 
  8. REMOVE DECK SIDE TRIM BOX LH  (See REMOVAL )
  9. REMOVE DECK BOARD NO.1 CHECK 
    1. Remove the 4 nuts and deck board No.1 check.
  10. REMOVE BRAKE CONTROL POWER SUPPLY ASSEMBLY 
    1. Disconnect the brake control power supply assembly connector and separate the clamp.
      Fig 1: Locating Brake Control Power Supply Assembly Connector And Clamp
      G05277004Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 nuts and the brake control power supply assembly.
      Fig 2: Locating Brake Control Power Supply Assembly Nuts
      G05277005Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the 4 bolts and 2 brackets.
scientia non olet · About LEMON Manuals