Inspection Procedure

1. Check if the CAN communication system DTC is output (See DIAGNOSIS SYSTEM ).

   Result 

   RESULT CHART
   
   

   Condition	Proceed To
   DTC is not output	A
   DTC is output	B

B: REPAIR CAN COMMUNICATION SYSTEM 

A: Go to next step 

1. Check if the multiplex communication system DTC is output (See DTC CHECK / CLEAR ).

   Result 

   RESULT CHART
   
   

   Condition	Proceed To
   DTC is not output	A
   DTC is output	B

B: REPAIR MULTIPLEX COMMUNICATION SYSTEM 

A: Go to next step 

1. Connect Techstream to the DLC3.
2. Turn the ignition switch on.
3. Select the "ECB* Warning Lamp" in the Active Test and operate the brake control warning light by Techstream.

   ABS/VSC/TRAC: 

   ABS/VSC/TRAC ACTIVE TEST REFERENCE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   ECB(1) Warning Lamp	Brake control warning light	Warning light ON / OFF	Observe combination meter
   (1) Electronically Controlled Brake

4. Check that "ON" and "OFF" of the brake control warning lights are indicated on the combination meter when using Techstream.

   OK: The brake control warning lights turn on or off in accordance with the operation using Techstream. 

   HINT:

   If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE  ).

NG: Go to step 4 

OK: REPLACE SKID CONTROL ECU 

1. Check the combination meter assembly (See HOW TO PROCEED WITH TROUBLESHOOTING ).

   HINT:

   If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE, refer back to the table and proceed to the next step before replacing the part (See PROBLEM SYMPTOMS TABLE  ).

NG: REPLACE COMBINATION METER ASSEMBLY 

OK: END