LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2008 >> RX 400h AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control >> Steering Angle Sensor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Angle Sensor: Installation

  1. INSTALL STEERING ANGLE SENSOR 
    1. Install the steering angle sensor to the spiral cable sub-assembly.
      NOTE:
      • Engage the claws securely.
      • Do not damage the claws.
        • Fig 1: Identifying Steering Angle Sensor Claw
        G05276997Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL SPIRAL CABLE SUB-ASSEMBLY WITH STEERING ANGLE SENSOR  (See INSTALLATION )
  3. POINT FRONT WHEELS FACING STRAIGHT AHEAD 
  4. INSTALL STEERING COLUMN COVER (for Manual Tilt)  (See INSTALLATION )
  5. INSTALL STEERING COLUMN COVER (for Power Tilt and Power Telescopic)  (See INSTALLATION )
  6. CENTER SPIRAL CABLE  (See INSTALLATION )
  7. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  8. INSTALL STEERING PAD  (See INSTALLATION )
  9. INSTALL STEERING WHEEL NO.2 COVER LOWER  (See INSTALLATION )
  10. INSTALL STEERING WHEEL NO.3 COVER LOWER  (See INSTALLATION )
  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
  12. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM )

scientia non olet · About LEMON Manuals