Throttle Body: Installation

INSTALL THROTTLE BODY ASSEMBLY
1. Install a new throttle body gasket to the intake air connector.
  
  Fig 1: Identifying Throttle Body Gasket
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the throttle body assembly with the 4 bolts.
  Torque: 11 N*m (112 kgf*cm, 8 ft.*lbf)
  
  Fig 2: Locating Throttle Body Assembly And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the fuel vapor feed hose (A).
4. Connect the water by-pass hose No.3 (B).
5. Connect the water by-pass hose No.2 (C).
6. Connect the throttle motor connector (D).
  
  Fig 3: Locating Throttle Body Assembly And Water By-Pass Hose
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER CASE W/ RESONATOR
1. Install the air cleaner hose No.1 to the throttle body assembly with the hose clamp.
  
  Fig 4: Locating Air Cleaner Hose No.1 Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the air cleaner case w/ resonator with the 5 bolts.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
  
  Fig 5: Locating Air Cleaner Case W/ Resonator And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the MAF meter connector.
4. Connect the 2 wire harness clamps to the air cleaner.
  
  Fig 6: Locating Wire Harness Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the ventilation hose No.2.
  
  Fig 7: Locating Ventilation Hose No.2
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL AIR CLEANER CAP W/ INLET
1. Install a new air cleaner element to the air cleaner case.
2. Install the air cleaner cap w/ inlet with the 4 clamps.
3. Install the air cleaner cap w/ inlet with the 2 bolts.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
  
  Fig 8: Locating Air Cleaner Cap W/ Inlet And Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL COOL AIR INTAKE DUCT SEAL (See INSTALLATION )
ADD COOLANT (for Engine) (See COOLANT (FOR ENGINE) )
INSPECT FOR COOLANT LEAK (for Engine) (See COOLING SYSTEM )
INSTALL COWL TOP PANEL SUB-ASSEMBLY OUTER (See INSTALLATION )
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (See INSTALLATION )
INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH (See INSTALLATION )
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSTALL ENGINE ROOM COVER SIDE (See INSTALLATION )
INSTALL ENGINE ROOM SIDE LH COVER NO.2 (See INSTALLATION )
PERFORM INITIALIZATION
Some system need initialization when reconnecting the battery cable. (See INITIALIZATION )