Data List / Active Test

HINT:

Using the Techstream to read the DATA LIST allows the value or states of switches, sensors, actuators and other item values to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST early in troubleshooting is one way to save diagnostic time.

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Cruise Control / Data List.
5. According to the display on the Techstream, read the Data List.

   ECM (cruise control) 

   ECM (CRUISE CONTROL)
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   CCS Vehicle Spd	Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)	Actual vehicle speed	-
   CCS Mem Vehicle Spd	Memory vehicle speed / min.: 0 km/h (0 mph), max.: 200 km/h (125 mph)	Actual stored vehicle speed	-
   Throttle Opening Angle	Throttle opening angle / min.: 0° max.: 125°	Actual required throttle opening angle	-
   Cruise Operation Status	PNP switch signal (D position) / ON or OFF	ON: Shift lever on D OFF: Shift lever not on D	-
   Cruise Control	Cruise control system active condition / ON or OFF	ON: Cruise control system activated OFF: Cruise control system inactivated	-
   CCS Indicator M-CPU	Cruise control main switch alternate signal change (Main CPU) / ON or OFF	ON: Cruise control main switch signal is ON OFF: Cruise control main switch signal is OFF	-
   CCS Ready M-CPU	Cruise control system stanby condition (Main CPU)/ON or OFF	ON/OFF: Chane ON/OFF each time main SW is pushed in.	-
   MAIN SW M-CPU	Cruise main switch signal (Main CPU) / ON or OFF	ON: Cruise control main switch is ON (Main CPU) OFF: Cruise control main switch is OFF (Main CPU)	-
   CANCEL Switch	CANCEL switch signal / ON or OFF	ON: CANCEL switch ON OFF: CANCEL switch OFF	-
   SET/COAST Switch	-/SET switch signal / ON or OFF	ON: -/SET switch ON OFF: -/SET switch OFF	-
   RES/ACC Switch	+/RES switch signal / ON or OFF	ON: +/RES switch ON OFF: +/RES switch OFF	-
   Stp Light SWM-CPU	Stop light switch signal (Main CPU) / ON or OFF	ON: Brake pedal is depressed OFF: Brake pedal is released	-
   # Codes	Number of present trouble codes/ min.:0, max.:255	number of DTCs will be displayed	-

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuatior and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
5. According tot he display on the Techstream, perform the Active Test.

   Combination meter assembly 

   TESTER DISPLAY CONDITION CHART
   
   

   Tester Display	Test Part	Control Range
   Indicat. Lamp Cruise	Cruise indicator light / ON or OFF	Confirm that vehicle is stopped and engine is idling