Data List / Active Test

HINT:

Using the Data List displayed on the techstream, you can read the value of the switch, sensor, actuator etc. without parts removal. Reading the Data List as the first step in troubleshooting is one way to shorten the labor time.

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to the ON position.
3. Turn the tester ON.
4. Enter the following menus: Body Electrical / desired system / Data List.
5. According to the display on the tester, read the "Data List".

   Immobilizer: 

   IMMOBILIZER
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   KEY SW	Unlock warning switch signal / ON or OFF	ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder	-
   IG SW	Ignition switch signal / ON or OFF	ON: Ignition switch ON or ACC OFF: Ignition switch OFF
   Immobilizer	Immobilizer system status / SET or UNSET	SET: No key is in ignition key cylinder UNSET: Ignition switch ON
   Permit (start)	Permit (start) signal / OK or NG	OK: Engine start is permitted NG: Engine start is not permitted
   Response	Transponder chip data / NG or OK	NG: Data error OK: Data OK
   Frame Error
   Different Serial Number
   Diggerent Encrypt Code
   Abnormal Status
   Bcc Malfunction	-
   Sub Key	Sub-key code signal / Unreg or Reg	Unreg: Unmatched sub-key code is sent Reg: Registered sub-key code is sent
   Master Key	Master key code signal / Unreg or Reg	Unreg: Unmatched master key code is sent Reg: Registered master key code is sent
   Transponder S-code	Number of registered sub-keys / min.:0, max.:3	Number of registered sub-keys
   Transponder M-code	Number of registered master keys /min.: 0, max.: 5	Number of registered master keys
   Reg Code Space Full	Memory space for key code registration / No or Yes	N0: Possible to register more key codes Yes: Cannot register any more key codes

   Theft Deterrent: 

   THEFT DETERRENT
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Acc SW	Ignition switch signal / ON or OFF	ON: Ignition switch ON or ACC OFF: Ignition switch OFF	-
   IG SW

HINT:

Performing the Active Test using the Techstream allows relay, VSV, actuator etc. to operate without removing any parts. Performing the Active Test early as the first step of troubleshooting is one way to shorten labor time.

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to the ON position.
3. Turn the tester ON.
4. Enter the follwoing menus: Body Electrical / Immobolizer / Active Test.
5. According to the display on the tester, perform the "Active Test".

   Immobilizer: 

   IMMOBILIZER
   
   

   Item	Test Details	Control Range	Diagnostic Note
   Security Indicator	Security indicator light	ON / OFF	-