Quarter Window Glass: Removal

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the RH side.

1. OPEN ROOF PANEL HALFWAY 
   Fig 1: Identifying Open Roof Panel Halfway

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Refer to the MANUAL OPERATING procedures and half open the roof.
2. REMOVE REAR SEAT CUSHION ASSEMBLY (See  REMOVAL  ) 
3. REMOVE REAR SEAT HEADREST PLATE COVER (See  REMOVAL  ) 
4. REMOVE WIND DEFLECTOR BOARD ASSEMBLY (See  REMOVAL  ) 
5. REMOVE REAR SEAT HEADREST PLATE (See  REMOVAL  ) 
6. REMOVE REAR SEAT HEADREST ASSEMBLY (See  REMOVAL  ) 
7. REMOVE REAR SEATBACK ASSEMBLY (See  DISASSEMBLY  ) 
8. REMOVE DOOR SCUFF PLATE ASSEMBLY RH (See  DISASSEMBLY  ) 
9. REMOVE QUARTER TRIM PANEL ASSEMBLY FRONT RH (See  REMOVAL  ) 
10. REMOVE CENTER PILLAR UPPER END WEATHERSTRIP RH 
    1. Using a clip remover, detach the 4 clips.
    2. Remove the weatherstrip.
       Fig 2: Identifying Weatherstrip And Clips

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
11. REMOVE QUARTER BELT MOULDING RH 
    1. Using a moulding remover, remove the moulding.
       Fig 3: Identifying Quarter Belt Moulding RH

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
12. REMOVE LUGGAGE COMPARTMENT DOOR WEATHERSTRIP 
    1. Using a clip remover, detach the 3 clips.
    2. Remove the front part of the door weatherstrip.
       Fig 4: Identifying Front Part Of Door Weatherstrip

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
13. REMOVE REAR SPEAKER ASSEMBLY (See  REMOVAL  ) 
14. REMOVE QUARTER WINDOW ASSEMBLY RH 
    1. Remove the connector and grommet.
    2. Remove the 2 bolts and 4 nuts.
    3. Remove the quarter window.
       Fig 5: Identifying Quarter Window Assembly

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
15. REMOVE QUARTER WINDOW STOP 
    1. Remove the 2 bolts and 2 window stops.
       Fig 6: Identifying Quarter Window Stop

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
16. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH 
    1. Remove the 2 screws, regulator base plate and regulator motor.
       Fig 7: Identifying Regulator Base Plate And Regulator Motor

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
17. REMOVE QUARTER WINDOW ASSEMBLY RH 
    1. When reusing the regulator:

       Place matchmarks on the regulator to indicate the position of the nuts.

       Fig 8: Identifying Matchmarks On Regulator

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 3 nuts and quarter window.
       Fig 9: Identifying Quarter Window And Nuts

       Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002