Ventilation Valve: Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL VENTILATION VALVE SUB-ASSEMBLY
1. Install the valve.
  1. Apply adhesive to 2 or 3 threads.
    Adhesive:
    
    Toyota genuine adhesive 1324, three bond 1324 or equivalent
    
    Fig 1: Applying Adhesive To Threads
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Install the valve.
    Torque: 27 N*m (275 kgf*cm, 20 ft.*lbf)
    
    Fig 2: Identifying Valve
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    
    HINT:
    
    After applying the specified torque, rotate the valve clockwise with the port facing the direction shown in the illustration.
2. Install the ventilation valve cover.
  
  Fig 3: Rotating Valve Clockwise With Port Facing
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the hose to the valve.
INSTALL INTAKE AIR CONNECTOR PIPE
1. Connect the air hose and ventilation hose.
2. Install the bolt and intake air connector pipe with the bolt.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
3. Tighten the 2 hose clamps.
  
  Fig 4: Connecting Hose To Valve
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 AIR CLEANER INLET
1. Install the inlet with the bolt.
  Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf)
INSTALL V-BANK COVER
1. Install the cover with the 2 nuts.
  Torque: 5.0 N*m (51 kgf*cm, 44 ft.*lbf)