MULTI-DISPLAY (w/ Navigation System): Installation

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL MULTI-DISPLAY (CENTER DISPLAY)
1. Install the multi-display.
2. Connect the 4 connectors and install the clamp.
3. Install the harness clamp with the 2 screws.
  
  Fig 1: Identifying Wiring Harness Clamp And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the 2 screws.
  
  Fig 2: Locating Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Install the No. 2 retainer with the 5 screws.
  
  Fig 3: Locating Instrument Panel Finish Panel No. 2 And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Install the No. 1 retainer with the 6 screws.
  
  Fig 4: Locating Instrument Panel Finish Panel No. 1 Retainer And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Install the instrument panel finish upper panel with the 4 screws to the both sides.
  
  Fig 5: Locating Instrument Panel Finish Upper Panel Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER
1. Connect the connector and detach the clip.
2. Install the panel with the 2 bolts and 2 screws.
  
  Fig 6: Locating Instrument Cluster Finish Panel Bolts And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT PANEL SAFETY PAD GARNISH SUB-ASSEMBLY (See INSTALLATION )
INSTALL AIR CONDITIONING CONTROL ASSEMBLY (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK SRS WARNING LIGHT (See INSTALLATION )