MULTI-DISPLAY (w/ Navigation System): Removal

WARNING: This page is about a different car, the 2007 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE AIR CONDITIONING CONTROL ASSEMBLY (See REMOVAL )
REMOVE INSTRUMENT PANEL SAFETY PAD GARNISH SUB-ASSEMBLY (See REMOVAL )
REMOVE NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY (See REMOVAL )
REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER
1. Remove the 2 bolts and 2 screws.
2. Disconnect the connector. Then remove the multi-display (with panel) and clip.
  
  Fig 1: Locating Instrument Cluster Finish Panel Bolts And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE MULTI-DISPLAY (CENTER DISPLAY)
1. Remove the 4 screws on the both sides of the instrument panel finish upper panel.
  
  Fig 2: Locating Instrument Panel Finish Upper Panel Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 6 screws and instrument panel finish panel No. 1 retainer.
  
  Fig 3: Locating Instrument Panel Finish Panel No. 1 Retainer And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 5 screws and instrument panel finish panel No. 2 retainer.
4. Remove the instrument cluster finish center lower panel.
  
  Fig 4: Locating Instrument Panel Finish Panel No. 2 And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 2 screws.
  
  Fig 5: Locating Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the 2 screws and wiring harness clamp.
7. Disconnect the 4 connectors, then remove the clamp.
8. Remove the multi-display.
  
  Fig 6: Identifying Wiring Harness Clamp And Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002